Finally, the path to the currently selected image is shown along the bottom of the window, The bottom left area is a magnifier, where the contents of the image and overlay underneath the mouse crosshairsĪre magnified by a factor of 2X of the 100% image size. To exit the digitizer and save the current dataset, click OK to exit the digitizer while discarding your current work on the To the left of the OK and Cancel buttons.
Engauge digitizer tutorial professional#
However, CurveExpert Professional supports digitizing from XY plots with the x and/or y axis on a log scale, and also supports Once the image is in place, you may select the type of the graph in the image from the toolbar. Click the Calibrate… button, and follow the prompts that are given beneath the toolbar. ForĪn XY plot, you will first click on the leftmost tick mark possible on the x axis, and then click on the rightmost tick mark possible on the x axis. Location of the point you chose by hovering the mouse over the red dot that you just created, and using the keyboard arrows to shift the dot You will soon be asked which data values (in the x direction) these two tick marks correspond to. Until it adequately lines up with both the axis and tick mark. A red dot will be placed to indicate each Use the magnifier to aid in this fine tuning. Of your calibration points, connected by a red line. The canvas will look similar to the screenshot below. You may fine-tune the calibration points at a later time as well.Īfter specifying the X axis calibration, we will now specify the calibration for the Y axis. Once the second Y calibration point is selected, the calibration dialog will appear to allow you to input the data values The Y axis calibration points will be indicated by green points In the same manner as the X axis was calibrated, click on the YĪxis at the lowest possible tick mark on the Y axis, and then at the highest possible tick mark on the Y axis. Remember that you can still fine-tune the location of the calibration points by pointing at them with the mouse and After filling in this information, your calibration data values will display in red or green next to the That corresponding to each of the calibration points this is shown in the screenshot below.įor XY plots, you will specify the data values for the two points selected on the X axis, and thenįor the two points selected on the Y axis. Using the arrow keys to move the calibration point to the desired location. Any data points that you have already created will be automatically adjustedĪlso, if you desire to replace the current calibration with a completely new one (as opposed to fine-tuning the existing calibration), simply clickĪs you move the mouse over the image, you will notice that the Image Coordinates and Data Coordinates information bars will begin to show informationĬoncerning the current mouse location. The data coordinate is the transformed data value The image coordinate is the pixel location within the image.
0 kommentar(er)
